Home Kovove Materialy-Metallic Materials 2011 Metallic Materials Vol. 49 (2011), no. 3, pp.213-217

Journal info

Select Journal







Webshop Cart

Your Cart is currently empty.

Info: Your browser does not accept cookies. To put products into your cart and purchase them you need to enable cookies.

Metallic Materials Vol. 49 (2011), no. 3, pp.213-217

Title: Thermal and mechanical stability of Mg based nanocomposite studied by internal friction measurements
Author: TROJANOVA, Z., MAKOWSKA, A., RIEHEMANN, W., LUKAC, P.

Abstract: Magnesium matrix composites show improved wear resistance, enhanced strength and creep resistance in comparison with their monolithic counterparts, on the other hand they keep low density and good machinability. Internal friction measurements are suitable tool to detect changes in the microstructure of thermally or mechanically loaded composites. Samples from pure magnesium reinforced with zirconia nanoparticles were thermally cycled between room temperature and increasing upper temperature of thermal cycle. After thermal cycling amplitude dependence of decrement was measured. Very high values of the logarithmic decrement were ascribed to the poor binding between the matrix and ceramic nanoparticles. The influence of cyclic bending on the damping behaviour of the same nanocomposite was determined at room temperature. Measured decrease of the resonant frequency indicates the stiffness loss as a function of cycling. Observed decrease of amplitude independent component of decrement at the end of the sample life time is due to increase of the dislocation density. These dislocations can be absorbed by the interface. Crack deflection along an interface is followed by the separation of the particle/matrix interface.

Keywords: magnesium nanocomposite, internal friction, dislocations, bending test, fatigue
Year: 2011, Volume: 49, Issue: 3 Page From: 213, Page To: 217
doi:10.4149/km_2011_3_213
Price: 2.50 €






© AEPress s.r.o
Copyright notice: For any permission to reproduce, archive or otherwise use the documents in the ELiS, please contact AEP.