Home FOR AUTHORS Kovove Materialy-Metallic Materials 2018 Metallic Materials Vol. 56 (2018), no. 1, pp.41-53

Journal info

Select Journal







Webshop Cart

Your Cart is currently empty.

Info: Your browser does not accept cookies. To put products into your cart and purchase them you need to enable cookies.

Metallic Materials Vol. 56 (2018), no. 1, pp.41-53

Title: An investigation of moldability and mechanical properties of MgO added alumina
Author: O. ERDEM, L. URTEKIN, I. USLAN

Abstract: In this study, the influence of MgO addition to mechanical properties of the injection molded alumina was investigated. Firstly, alumina feedstocks (without adding MgO) were prepared to determine the optimum powder/binder ratio by the capillary rheometer. Then, MgO was added at 0.5, 1 and 1.5 wt.% to alumina feedstocks at the optimum ratio. Moldflow simulation analysis (MSA) was performed to obtain injection parameters (injection pressure, flow rate and feedstock temperature) before the real molding operation. Through the agency of the pre-operating parameters obtained from MSA, preliminary trials were carried out by molding machine for successful specimens (tensile and bending). By comparison of experimental and analytical results, the error rate of injection parameters was determined for both specimens. The maximum strengths of bending and tensile test values were found 158 MPa and 69 MPa (in specimens containing 1 wt.% MgO), respectively. Analysis of SEM revealed that specimens containing 1 wt.% MgO have less porosity.

Keywords: alumina, powder injection molding, rheology, sintering, moldability
Published online: 27-Feb-2018
Year: 2018, Volume: 56, Issue: 1 Page From: 41, Page To: 53
doi:10.4149/km_2018_1_41


download file



© AEPress s.r.o
Copyright notice: For any permission to reproduce, archive or otherwise use the documents in the ELiS, please contact AEP.