Home Kovove Materialy-Metallic Materials 2018 Metallic Materials Vol. 56 (2018), no. 5, pp. 289-295

Journal info

Select Journal







Webshop Cart

Your Cart is currently empty.

Info: Your browser does not accept cookies. To put products into your cart and purchase them you need to enable cookies.

Metallic Materials Vol. 56 (2018), no. 5, pp. 289-295

Title: Influence of Al content on machinability of AM series magnesium alloys
Author: B. AKYUZ

Abstract: This study investigates the effects of Al (aluminium) amount in AM series magnesium alloys on mechanical properties and machinability (cutting forces). Changes in microstructure and mechanical properties and their effects on cutting forces were analysed depending on the increase in Al amount. For this reason, AM series magnesium alloys (AM20, AM40, AM60, and AM90) with varying amounts of Al % (from 2 to 9 %) were used in the study. It was observed that in AM series magnesium alloys (containing 0.5 % Mn), intermetallic phases found in microstructure (Mg17Al12 and Al8Mn5) improved the mechanical properties and lowered machinability by rising the cutting forces (Fc) depending on the increase in Al amount. Also, the surface roughness (Ra) of intermetallic phases was observed to have an impact on flank build-up – FBU and chip formation. While AM90 had the highest values in terms of mechanical properties and surface quality, AM20 had the lowest values. On the other hand, AM20 had the highest El% values and machinability properties.

Keywords: machinability, cutting force, AM series magnesium alloys, flank build-up (FBU), surface roughness, chip formation
Published online: 24-Oct-2018
Year: 2018, Volume: 56, Issue: 5 Page From: 289, Page To: 295
doi:10.4149/km_2018_5_289


download file



© AEPress s.r.o
Copyright notice: For any permission to reproduce, archive or otherwise use the documents in the ELiS, please contact AEP.